Laboratory instruments and their uses pdf

Posted on Saturday, June 19, 2021 12:06:49 PM Posted by Simone C. - 19.06.2021 and pdf, guide pdf 0 Comments

laboratory instruments and their uses pdf

File Name: laboratory instruments and their uses .zip

Size: 27315Kb

Published: 19.06.2021

This type of flask has a narrow neck and a flat bottom. Design elements - Laboratory equipment The vector stencils library "Laboratory equipment" contains 31 clipart icons of chemical laboratory equipment and labware for drawing part assembly … Autoclave 8. Add to Likebox - Chemical and testing icons sets.

20 common School Science laboratory equipment and their uses?

Jonny-Ringo, first and foremost, loves to read and write. One of his specialities is writing on chemistry. In most labs, you'll encounter the same basic apparatus.

Here, you will find a picture and an explanation for how to use each piece of equipment. You will learn about:. The first and foremost rule of any laboratory is to be safe! This may seem obvious, but people often disregard safety protocols for one reason or another, putting themselves and those around them in danger.

The best thing you can do is to make sure you follow all safety protocols at all times. Safety goggles are required wear in all chemistry labs. Not wearing them puts you in danger of eye irritation and possibly blindness in the case of an accident.

A small droplet of acid could splash out of the container at any time. Better safe than permanently blinded! Latex gloves should be used when there is a possibility of corrosive chemicals spilling onto your hands. A beaker is a common container in most labs. It is used for mixing, stirring, and heating chemicals. Most beakers have spouts on their rims to aid in pouring. They also commonly have lips around their rims and markings to measure the volume they contain, although they are not a precise way to measure liquids.

Beakers come in a wide range of sizes. Because of the lip that runs around the rim, a lid for a beaker does not exist. However, a watch glass discussed below can be used to cover the opening to prevent contamination or splashing. Also known as a conical flask, the Erlenmeyer flask was named after its inventor in It has a narrow neck and expands toward its base. This allows easy mixing and swirling of the flask without too much risk of spilling. The narrow opening also allows for the use of a rubber or glass stopper.

It can easily be clamped to a ring stand discussed below as well as heated or shaken mechanically. An important safety tip here is to never heat this flask while it is capped. This could cause a pressure build-up that could result in explosion. Also known as a boiling flask, the Florence flask has a round bottom and a long neck.

It is used to hold liquids and can be easily swirled and heated. It can also easily be capped by rubber or glass stoppers. Once again, safety dictates that this flask never be heated when capped.

Pressure build-up and explosions can and do occur. A test tube is a glass tube with one end open and the other end closed. The closed end is rounded. Test tubes are used to hold small samples. They are primarily used for qualitative assessment and comparison. A common place to see these is the biochemistry lab.

When a large number of samples need to be tested and compared, test tubes are used to make this easier. They are also easily capped with a rubber or glass stopper. They are generally held in a test tube rack specifically designed for the purpose. If the test tubes become unsafe to touch with bare hands whether due to heat or another reason , test-tube tongs can be used to move them. It can hold a small amount of liquid or solid. They can be used for evaporation purposes and also can function as a lid for a beaker.

A crucible is a small clay cup made of a material that can withstand extreme temperatures. They are used for heating substances and come with lids. A lab funnel is just like any other funnel except that it was designed to be used in a laboratory setting. They can be made of plastic or glass and can have either a short stem or a long stem, depending on what they are needed for.

There are several sizes that can be chosen from based on the amount of liquid that needs to go through them quickly. This is a primary measuring tool for the volume of a liquid. There are several markings up and down the length of the container with specific increments. Graduated cylinders come in many sizes. The smaller they are in diameter, the more specific the volume measurements will be. When reading the volume from a graduated cylinder, you will notice that the liquid seems to have an indentation.

The liquid around the edges will be higher than the liquid in the center, sloping down like the sides of a trampoline when someone is standing in the middle. This is called the meniscus. Line the lowest point of the meniscus up with the nearest marking, keeping the cylinder level to properly read the volume. A volumetric flask is a round flask with a long neck and flat bottom.

It is used to measure an exact volume of liquid. There is a small line on the neck that indicates how far to fill the bottle use the bottom of the meniscus. They come with special caps that will not let anything in or out. Remember that temperature affects volume; therefore avoid using liquids that will fluctuate in temperature hot water that will cool, for example.

These are small glass tubes with narrow tips on one end and a rubber bulb on the other. They suck up liquid that can then be squeezed out in small drops. These can be used to add an indicator to a solution about to be titrated.

There are a large variety of pipettes designed to accomplish specific goals. However, they are all for measuring an exact volume of liquid and placing it into another container. A buret. These are usually attached with a clamp to a ring stand, as shown in the picture below. A buret is a glass tube that is open at the top and comes to a narrow pointed opening at the bottom. Right above the bottom opening is a stopcock that can be turned to control the amount of liquid being released.

There are markings along the length of the tube that indicate the volume of liquid present. A buret is used for extremely accurate addition of liquid. By adjusting the stopcock, the amount of liquid that is released can be slowed to a drop every few seconds. Burets are one of the most accurate tools in the lab. To determine how much liquid is added, write down how much is initially in the buret.

Then when you're finished adding, write down how much is left. Subtract the final amount from the initial amount and you have the volume of liquid added. The ring stand is used to suspend burets, beakers, flasks, crucibles, etc. Always make sure everything is clamped to the stand tightly. When clamping glass, be careful not to shatter the glass. Only tighten until snug. When using a ring on the stand, there are usually other pieces necessary to accomplish the goal.

Wire mesh is laid across the ring to distribute evenly heat and support the beaker. A clay triangle with an open center is used to suspend crucibles. Tongs and forceps are for grabbing things that should not be touched by hand. Some tongs are specially made to hold beakers, others to hold test tubes, and so on.

There are also general tongs. Forceps are used to grab small things like solid chemicals that are broken into chunks, so they can be safely handled and added to containers. Three scoopulas on the left and a number of spatulas to the right. Spatulas and scoopulas are for scooping solid chemicals. They are typically used to scoop a chemical out of its original container onto a weigh boat so that it can be weighed on a balance.

A laboratory thermometer is used for measuring the temperature of liquids. It can be made of glass or it can be a thermocouple made of different metals. A Bunsen burner is a mechanical apparatus that is connected to a flammable gas source. There is a knob to adjust the amount of gas flow and a rotating collar that controls airflow.

These both must be adjusted to get an ideal flame for heating purposes. The burner is lit with a striker. A balance is used to weigh chemicals. The chemicals are always in some form of container and never placed directly on the balance.

Laboratory Equipments

Godfrey Tanya Course Expectations. Basic Chemistry Lab Equipment Youtube. Lab Equipment. Scientific Equipment And Instruments. Laboratory Wikipedia.

Jonny-Ringo, first and foremost, loves to read and write. One of his specialities is writing on chemistry. In most labs, you'll encounter the same basic apparatus. Here, you will find a picture and an explanation for how to use each piece of equipment. You will learn about:.

Several types of equipment are required for any functional laboratory to operate properly. Be it a school, research, or a medical laboratory, special equipment is required. We take a look at the common lab equipment names and their uses. Laboratory equipment is used to carry out scientific experiments and range from simple tools to complex apparatus depending on the uses. While different types of laboratories need different types of apparatus, some are common to all. Some science lab equipment is used for weighing objects, mixing and preparing solutions, and others for cleaning vessels.

laboratory apparatus and their uses pdf

Laboratory services are provided in a variety of settings: physicians offices, clinics, hospitals, and regional and national referral centers. Laboratories used for scientific research take many forms because of the differing requirements of specialists in the various fields of science and engineering. A physics laboratory might contain a particle accelerator or vacuum chamber , while a metallurgy laboratory could have apparatus for casting or refining metals or for testing their strength. A chemist or biologist might use a wet laboratory , while a psychologist's laboratory might be a room with one-way mirrors and hidden cameras in which to observe behavior. In some laboratories, such as those commonly used by computer scientists , computers sometimes supercomputers are used for either simulations or the analysis of data.

PRO believes in listening precisely to what our customers need, then responding with a superior product. Homogenizers from PRO Scientific Handheld or Post-Mounted Laboratory Homogenizer Offering plenty of power and useful features, the Bio-Gen PRO homogenizer now has a watt, high-torque motor with a variable speed adjustment, allowing for homogenization in mere seconds and a maximum noise level of only 68 dB. Combining a high-watt motor and advanced technology in digital speed controls has resulted in the most reliable and durable laboratory benchtop homogenizer.

To browse Academia. Skip to main content. By using our site, you agree to our collection of information through the use of cookies. To learn more, view our Privacy Policy.

A List of Chemistry Laboratory Apparatus and Their Uses

Catalog excerpts

 - Я поняла это, сделав пробу системных функций. Мы выделили отдаваемые им команды - смотрите. Смотрите, на что он нацелен. Шеф систем безопасности прочитал текст и схватился за поручень. - О Боже, - прошептал.  - Ну и мерзавец этот Танкадо. ГЛАВА 110 Невидящими глазами Джабба смотрел на распечатку, которую ему вручила Соши.

Энсей Танкадо мертв, власти убеждены, что это сердечный приступ, прямо как в учебнике, кроме одного обстоятельства. Халохот ошибся с местом действия. Быть может, смерть Танкадо в публичном месте была необходимостью, однако публика возникла чересчур. Халохот был вынужден скрыться, не успев обыскать убитого, найти ключ. А когда пыль осела, тело Танкадо попало в руки местной полиции. Стратмор был взбешен. Халохот впервые сорвал задание, выбрав неблагоприятные время и место.

Все-таки он опоздал. Плечи Беккера обмякли. - А на этот рейс были свободные места. - Сколько угодно, - улыбнулась женщина.  - Самолет улетел почти пустой.

Laboratory Equipments

COMMENT 0

LEAVE A COMMENT